Vibration Maintenance And Detection Method For Iko Tapered Roller Bearing

Bearing maintenance is a necessary condition for the operation of Iko Tapered Roller Bearing tapered roller bearing. The common maintenance is for the lubrication of IKO tapered roller bearing.After reading how to select the lubrication mode of bearing and understanding the lubrication mode of bearing, it is also necessary to understand the maintenance of bearing system. Let’s see how to carry out bearing lubrication and maintenance.

Iko Tapered Roller Bearing

Keep the bearing lubrication clean：Before inspecting the tapered roller bearing, the surface of the bearing Iko Tapered Roller Bearing should be cleaned first, and then the oil seal of the bearing and its surrounding parts should be carefully inspected.
If there are bad symptoms, it must be replaced. The bad oil seal will cause damage, make the cloud of IKO bearing abnormal and cause Iko Tapered Roller Bearing the shutdown of the equipment.
Pay attention to covering exposed bearings：When checking tapered roller bearings, do not expose the Iko Tapered Roller Bearing bearings to pollutants or moisture. If the work is interrupted, the machine shall be covered with oil paper, plastic sheet or similar materials.
If it is possible to clean the naked bearing without disassembly, clean it with a brush coated with petroleum solvent, and then wipe it dry with a piece of lint free cloth or blow it dry with compressed air (be careful not to start the rotation of the bearing assembly).
Use a small mirror and a probe similar to that used by dentists to check the track surface, retainer Iko Tapered Roller Bearing and beads of IKO bearing. Do not clean the sealed cover or dust-proof bearing; Just wipe the outer surface. If the bearing is damaged, it needs to be replaced.
It is much more economical to replace the bearing during the regular shutdown and maintenance period than the loss of sudden Iko Tapered Roller Bearing shutdown due to the damage of the array bearing.

Check the lubricant of bearing

Lubricants are important not only for bearings, but also for all Iko Tapered Roller Bearing bearings. However, please note that tapered roller bearings should not add too much grease. Then it’s time to change the lubricant of the bearing.
After draining the old engine oil, if possible, the bearings lubricated with engine oil should be filled with fresh engine oil and let the machine rotate at low speed for a few minutes. Make the oil collect residual pollutants as much as possible, and then drain the oil.
When replacing the grease of IKO bearing lubricated with grease, the Joe remover used shall avoid cotton from contacting any part of the Iko Tapered Roller Bearing bearing. Because these residual fibers may wedge between rolling parts and cause damage, especially in bearing applications.
When the waviness of components is closely matched between the bearing ring and the bearing seat or transmission shaft, the bearing ring may be deformed by matching with the shape of adjacent components.
If deformation occurs, vibration may occur during operation. Therefore, it is important to machine the bearing pedestal and drive shaft to the required tolerances.
Local damage due to incorrect operation or installation, a small part of the bearing raceway and rolling element may be damaged. During operation, rolling over damaged bearing parts will produce a specific vibration frequency.
Vibration frequency analysis can identify damaged bearing components. Vibration behavior in applications in many applications, the stiffness of IKO bearings is the same as that of surrounding structures.
Because of this feature, as long as the bearing (including preload and clearance) and its configuration in the application are correctly selected, it is possible to reduce the vibration in the application.

We can provide samples for free

General Bearings

Specialized Bearings

OEM Bearings

Strategy and Planning

Strategy and Planning

Steps For Inspection And Maintenance Of Fag One-Way Bearing

Several Necessary Points For Attention When Using Fag Non-Standard Bearings

Vibration Maintenance And Detection Method For Iko Tapered Roller Bearing

Iko Tapered Roller Bearing

Check the lubricant of bearing

CONTACT US

Guarantees & Return policy

FOLLOW US:

Types of Bearings

Get Your Free Quote